Fujitsu PRIMERGY RX2540 M4 User Manual

52 Operating Manual RX2530 M4
Hardware installation
5.4 Connecting the server to the mains
In its basic configuration level the server has one PSU.
A second PSU can be added to ensure a redundant power supply. If one PSU
is defective, the other then guarantees unimpaired operation. In this case, the
defective PSU can be replaced during operation (see the "PRIMERGY
RX2530 M4 Server Upgrade and Maintenance Manual").
V CAUTION!
The AC PSU is automatically set to a mains voltage in the range 100 -
240 V (PSU Platinum) or 200 - 240 V (PSU Titanium). You may only
operate the server if its rated voltage range corresponds to the local
mains voltage.
I As an option, the server can be equipped with a DC PSU that adjusts
automatically to any power voltage in the range from -40.5 V to -57 V.
Ê Connect the power cord to the PSU.
Ê Connect the mains connector to an outlet on the rack's socket strip (see also
Technical Manual for the rack).
I A phase redundancy in the power supply of the server can be set up if
two PSUs are installed.
In this case, each of the PSUs is either connected to two different phases
or to two separate circuits of the internal power supply network.

Fujitsu PRIMERGY RX2540 M4 Specifications

General

Processor	Intel Xeon Scalable Processor Family
Form Factor	2U rack server
Chipset	Intel C621
Memory	Up to 3TB DDR4
Storage	Up to 24 x 2.5-inch SAS/SATA/NVMe drives or Up to 12 x 3.5-inch SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60 (with optional controller)
Expansion Slots	Up to 8x PCIe Gen3 slots
Power Supply	800W or 1200W (1+1 redundant)
Memory Type	DDR4
Management	iRMC S5 (Integrated Remote Management Controller)
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware