1. INSTALLATION
5
Wiring
The illustration below shows how to connect the power supply. Other equipment are
connected similarly.
J1
(1) Unfasten screws.
(2) Pull out terminal.
- +
(3) Insert wire into terminal,
and tighten screw at top
of terminal.
J2
J3
AFT FWD 13.6V
- + - + - +
TERMINAL ARRANGEMENT
0V 0V 0V 0V 0V4 CAL4
MIC PTT AUX ALRM SP4
J3
- + - + - +
AFT FWD 13.6V
J1
0V3 CAL3 SP2 0V1 CAL1
SP3 0V2 CAL2 SP1
J2
(4) Set terminal;
tighten screws.
Jeweler’s
screwdriver
Note: Connect power cables
to the battery correctly.
ppppp
pppp p p
LH-3000, rear panel, how to wire terminals
To Next Page
Need help?
General
