Installation Instructions
D PREPARE THE AIR CONDITIONER
(continues)
[_ Remove the ground screw from the left
side of the case. Keep it in a safe location.
NOTE: Be sure to save this screw. You will need
them later in the installation.
[] Slide the air conditioner from the case by
gripping the base pan handle and pulling
forward while bracing the case. Do not
pull or lift on the styrofoam discharge area.
Do not
pull
area i
damage
to the
unit may
result
FRONT
D PREPARETHE CASE
[] Attach the top rail gasket to the bottom
of the top rail.
[-_ Install the top mounting rail with 4 type A
screws from the inside of the case. Press
firmly to drive the screws into the gasket
and through the top mounting rail.
0
D PREPARETHE CASE
r-c] Slide each side retainer onto the edge of
each according panel. The figure shows teh
orientation of each accordion panel and side
retainer assembly relative to the case from a
top view of the unit.
SIDE RETAINER
[] Slide the left and right accordion panels
into the top and bottom mounting rails.
Top!eft_ ., _ P_
Topmo nting rail To ight
/
Bottom mounting rail
E] Attach the side retainers to the case using 6
type A screws.
....o o]} y