GEAppliances.com
Do Not Operate in Freezing Outdoor Conditions
Thiscool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote Control
Toensure proper operation, dim the remote
control ot the signal receiver on the air
conditioner.
Hake sure nothing is between the air conditioner
and the remote control that could block the
signal.
Theremote control signal has o range of
up to 20 feet.
Make sure batteries ore fresh and installed
correctly os indicated on the remote control.
Remotecontains o magnet allowing it to attach
to metal surfaces.
Cool Mode
Usethe Cool mode atLow, Med, High or Auto Fan
Speedfor cooling. Usethe Temperature Increase •
/ Decrease • podsto set the desiredtemperature
between 64°F and 86°F in l°F increments.
An electronicthermostat isusedto maintain the room
temperature. Thecompressorwill cycle on
and off to keep the room ot the set level of comfort.
Setthe thermostat ot o lowernumber and the indoor
air will become cooler.Setthe thermostat ot o higher
number and the indoor air will become warmer.
NOTE:If theair conditioner isoff ond is then turned on
while set to o Cool setting or if turned from o fan
setting to o Cool setting,it may take approximately
3 minutes for the compressor to start and cooling to
begin.
Cooling Descriptions
For Normal Cooling-Select the Cool mode and
High orF/ed fan with o middle set temperature.
For Maximum Cooling--Select the Cool mode
and High fan with o lower set temperature.
For Quieter and Nighttime Cooling-Select the
Cool mode and Low fan with o middle set
temperature.
Energy Saver Mode
Controlsthe fan.
ON--The fan will cycleon and off with the
compressor.This resultsin wider variations of room
temperature and humidity. Normally used when the
room isunoccupied. NOTE:Thefan may continue to
run for a short time after thecompressor cyclesoff.
OFF--Thefan runsoil the time, while the compressor
cycles on and off.
Fan Only Mode
Usethe Fan Only Node ot Low, Ned or High fan
speedto provide air circulation and filtering without
cooling. Sincefan-only settings do not provide
cooling, o Settemperature cannot be entered. The
room temperature will appear in the display.
NOTE:Auto FanSpeedcannot be usedwhen in the
Fan Only Mode.
Auto Fan Speed
Setto Auto fan speedfor the fan speedto
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needsmore cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speedwill automatically decrease.
NOTE:Auto FanSpeedcannot be used when in the
Fan Only Mode.
Power Outage Recovery Feature
Inthe case of o power outage or interruption, the
unit will automatically restart in the settings last
used offer the power isrestored. Ifthe Delay 1-24hr
feature was set,it will resume countdown. You may
need to set o new time if desired.
To Next Page
Loading...
Need help?
General
