GE CGS980SEMSS - 30" Gas Range Dimensions And Installation Information

For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
®
service, 800.626.2000.
Specification Revised 10/10
230151
Electrical Requirements: 120v; 60Hz, 15A
Effective January 1, 1996, the National Electrical Code
requires that new construction (not existing) utilize a 4-
conductor connection to an electric range.
Receptacle Locations: Locally approved flexible service
cord or conduit must be used because terminals are
not accessible after range installation. See shaded
area in drawing for location of electrical outlet box.
Recommended outlet locations allow range to be installed
directly against wall.
Note: 30" ranges conform to U.L. requirements for 0"
spacing from adjacent walls below countertops. To reduce
possibility of scorching walls, engineering recommends a
minimum of
1-1/2" spacing to allow for possible extended, high-heat,
no-load heating element operation.
Installation information: Before installing, consult
installation instructions packed with product for current
dimensional data.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Dimensions and Installation Information (in inches)
CGS980SEMSS
GE Café 30" Free-Standing Range with Baking Drawer
30"
26-1/2"
46-3/4"
36-1/4"
+
_
1/4*
9
30
2
4
4
24
13
14-1/2
2-1/2
Recommended area
for thru the floor
connection of pipe stub
and shut-off valve
Recommended common
area for gas outlet and
electrical outlet
*Dimension from floor to top of
the cooktop. Floor to top of rear
vent trim is 37-1/4”
Recommended
area for 120V outlet
on rear wall and
area for thru the
wall connection
of pipe stub and
shut-off valve

GE CGS980SEMSS - 30" Gas Range Specifications

General

Brand	GE
Model	CGS980SEMSS - 30" Gas Range
Category	Ranges
Language	English