Installation Instructions
CONNECTING DISPOSERTO SINK FLANGE
%
ATTACHTO SINK FLANGE
I,ine up the disposer
under the sink flange.
Guide the hopper Mount
projections into the RingSlot
mount ring slots. Turn Hopper
the mount ring about Projection
1/4" to the right so
that the disposer is
temporarily supported.
[] LINE UPWITH OUTLET PIPE
Turn the mount ring and the disposer until the
disposer discharge elbow lines up with the outlet
pipe (see page 8).
Discharge
Elbow
OutletPipeJl
131LOCK MOUNT RING
Turn the mount ring slowly to the right until it
locks up tight. Hopper projections must be to the
extreme left of the mounting slots. If the mount
ring is hard to turn, you may add a small amount
of petroleum jelly or liquid soap to the hopper
projection. Run water and check for leaks.
LockingDetail
HopperProjectionin
"Supported"Position
HopperProjection Mount
in "Locked"Position MountingSlot Ring
CHECK FOR LEAKS
Gheck the unit for leaks 24 hours after installation
and first operation.
7
To Next Page
Loading...
Need help?
General
