-１-
1. SAFETY INSTRUCTIONS
1.1 Installation
★ Condensation may occur if the UPS is moved directly from a cold to a warm
environment. The UPS must be absolutely dry before being installed. Please
allow an acclimatization time of at least two hours.
★ Do not install the UPS near water or in damp environment.
★ Do not install the UPS where it would be exposed to direct sunlight or near heat.
★ Do not block ventilation openings in the UPS’s housing.
★ Do not connect appliances or items of equipment which would overload the UPS
(e.g. laser printers, etc) to the UPS outlet sockets.
★ Place cables in such a way that no one can step on or trip over them.
◇ Installation for EP 700/1000/2000/3000
★ Socket-outlets and socket of batteries are earthed by the input power cord, please
insert the power cord into mains socket before using of UPS.
★ Connect the UPS only to an earthed shockproof socket outlet.
★ The building wiring socket outlet (shockproof socket outlet) must be easily
accessible to close to the UPS.
★ This is operator installable.
◇ Installation for EP6000
★ UPS has provided earthed terminal, in the final installed system configuration,
equipotential earth bonding to the external UPS battery cabinets.
★ An integral single emergency switching device which prevents further supply to the
load by the UPS in any mode of operation should be provided in the building wiring
installation.
★ An appropriate disconnect device as short-circuit backup protection should be
provided in the building wiring installation.
★ For three-phase equipment connection to an IT power system, a four-pole device
which disconnect all phase conductors and the neutral conductor should be
provided in the building installation wiring.
★ This is permanently connected equipment , it must be installed by qualified
Please read the FOLLOWING user manual and the safety instructions
before installing the unit and starting it up!
To Next Page
Loading...
Need help?
General