AF-300
Instructions
MICRO-$AVER
II
1/4 - 5 Horsepower
TM
i
These instructions do not purport to cover all details or variations in equipment, nor to provide for
every possible contingency to be met during installation, operation, and maintenance. Should
further information be desired or should particular problems arise that are not covered sufficiently for
the purchaser's purpose, the matter should be referred to GE Fuji Electric, Customer Service.
This document contains proprietary information of GE Fuji Electric and is furnished to its customers
solely to assist that customer in the installation, testing, and/or maintenance of the equipment
described. This document shall not be reproduced in whole or in part nor shall its contents be
disclosed to any third party without the written approval of GE Fuji Electric.
NOTE: The terms "inverter", "controller", and "drive" are sometimes used interchangeably through-
out the industry. We will use the term "Drive" in this document.
AF-300 Micro-Saver II™ and X$D™ are trademarks of General Electric Company. Energy Saver®
is a registered trademark of General Electric Company.
The terms "AF-300 Micro-Saver II" and AF-300M$II will be used interchangeably throughout this
document.
SHOCK HAZARD
labels may be located on or inside the Drive to alert people that dangerous
voltage may be present. (Refer to Section 1: Safety Precautions for Warnings and Cautions.)
Blank space has been intentionally left at the bottom of each page for the convenience of the user
in documenting notes.
WARNING: Always read the complete instructions
prior to applying power or troubleshooting the equipment
and follow all procedures step by step.
General Information – AF-300 Micro-$aver II
™
Drive Instructions
To Next Page
Need help?
General
