Removing the Filter Cartridge
If you are replacing the cartridge, first remove the old
one by slowly turning it to the left. Pull down gently on the
cartridge. A small amount of water may drip down.
To reduce the risk associated with
property damage due to water leakage read and follow
instructions before installation and use of this system.
Installation and use MUST comply with all state and local
plumbing codes. The disposable filter cartridge should be
replaced every six months, at the rated capacity or sooner
if a noticeable reduction in flow rate occurs.
Installing the Filter Cartridge
1. On models without a replacement indicator light, apply
the month and year sticker to the new cartridge to
remind you to replace the filter in six months.
2. Remove the protective foil from the end of the cartridge.
3. Posiition the cartridge inside the cartridge holder and
slowly rotate the cartridge to the right (clockwise) until it
stops. The cartridge will rotate about a 1/4 turn. When
installed correctly, the grip blade on the end of the
cartridge should be positioned vertically for top-freezer
models and horizontally for bottom freezer models. DO
NOT OVERTIGHTEN.
4. Close the cartridge cover.
5. On models with a replacement idicator light, press and
hold the RESET WATER FILTER PAD on the dispenser
for three seconds.
Models with a Dispenser
Run water from the dispenser for 1-1/2 gallons
(approximately three minutes) to clear the system and
prevent sputtering.
NOTE: A newly installed water filter cartridge may cause
water to spurt from the dispenser.
Filter Bypass Plug
To reduce the risk of property damage due to water
leakage, you MUST use the filter bypass plug when a
replacement filter cartridge is not available. The dispenser
and the icemaker will not operate without the filter or filter
bypass plug.
Removing/Installing Replacement Filter Cartridge
2
To Previous Page
Loading...
Need help?
General
