GE JGP329 - Page 10

Cleaningthe glass cooktop surface,consomemode s;
Clean gour cooktap after
each spill. Use CERAMA
BRYTE® Ceramic Cooktop
Cleaner.
Normal Dailg Use Cleaning
ONLYuse CERAMABRVTE®CeramicCooktop
Cleaneron the glasscooktop. Other creams
may not be aseffective.
To maintain and protect the surface of your
glasscooktop, follow these steps:
%
Beforeusing the cooktop for the first time,
remove the burner grates and clean the
cooktop with CERAMABRYTE®Ceramic
Cooktop Cleaner.Thishelps protect the
top and makes cleanup easier.
[_] Daily useof CERAMABRYTE®Ceramic
Cooktop Cleanerwill help keep the
cooktop lookingnew.
[] Shakethe cleaning cream well. Apply a
few drops of CERAMABRYTE®Ceramic
Cooktop Cleanerdirectly to the cooktop.
[] Usea paper towel or CERAMABRYTE®
CleaningPad for Ceramic Cooktops to
cleanthe entire cooktop surface.
[] Use a dry cloth or paper towel to
remove all cleaning residue. No need to
rinse.
NOTE:It is verg important that gou DO NOT
heat the cooktop until it has been cleaned
thoroughlg.
Use a CERAMABRYTE®Cleaning
Pad for Ceramic Cool<tops.
Burned-On Residue
WARNING: DAMAGEragout
g/ass surface may occur if gou use scrub
pods other than those recommended.
[-_ Allow the cooktop to cool.
EE
Removethe burner grates and spread a
few drops of CERAMABRYTE®Ceramic
CooktopCleaner on the entire burned
residuearea.
@
Using the included CERAMABRYTE®
Cleaning Padfor Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
@
If any residue remains, repeat the steps
listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE®
Ceramic CooktopCleaner and a paper
towel.
The CERAMABRYTE® Ceramic
Cool<top.Scraper and all
recommended supplies are
available through our Parts Center.
.Seeinstructions under "To Order
Parts" section on next page.
NOTE:Do not use a dull or
nicked blade.
Heavg, Burned-On Residue
%
EE
Allow the cooktop to cool.
Removethe burner grates. Use a single-
edge razor blade scraper at
approximately a/45 ° angle against the
glass surface and scrape the soil. It will
be necessary to apply pressure to the
razor scraper in order to remove the
residue.
%
After scraping with the razor scraper,
spread a few drops of CERAMABRYTE®
CeramicCooktop Cleaner on the entire
burned residuearea. Use the CERAMA
BRYTE®Cleaning Padto remove any
remaining residue.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE®
Ceramic Cooktop Cleanerand a paper
towel.
10