Installation
Instructions
30" Built-In Wall Oven
JTP20, JTP25, JTP28, JTP48, JTPh0, JT912,
JT915, JT952, JT955, ZET938, ZET958
If you have questions, call 1.800.GE.CARES or visit our website at:
www.GEAppliances.com
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT-save these
instructions for local inspector's use.
• IMPORTANT-observe a,
governing codes and ordinances.
• Note to Installer--Be sure to leave these
instructions with the consumer.
• Note to ConsumermKeep these
instructions for future reference,
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE--This appliance must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Parts Included
Screws For
Installation
Metal
Bottom Trim
Plastic
Bottom Trim
Optional
Metal Bottom
Trim Assembly
(on some models)
Materials Needed
__ @ Wireaunts
Strain Relief Clamp Junction
for 1/2" conduit Box €_ _
36" of String
Tools Needed
1/8" Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
229c4053P505-5
31-10524-5 o6-o4JR
To Next Page
Need help?
General
