Reversing the Door Swing
11'i_e ( ixiHer
7b rever:se
the door
Parts included:
1, Top left case hinge
2. Bottom left case hinge
3° I,eft and right side decorative
hi_ge cover
4. Decorative hinge screw hole cover
_° Torx _*_driver bit
Too]is required:
L Phillips screv, dri_er
2, Ele(trk drill
To remove the door:
1, Flatten the shipph_g cartoi_ to use as
a pad.
2. Remove the 2 screws ai_d the toekick.
Set aside the screws a_d toekick for final
ii_stallatio_.
3, Use the supplied Torx _'>bit and electric
drill to remo_e the a°screws holdi_g the
top case hing>. Lift off the hing>. (Screws
will be used to insta]il the new hi_ge.)
4. Lift the door off the bottom case hi_ge.
5, Remo_e the bottom case hil_ge piI_ al_d
bracket.
Rotate the door:
The handle rdll be on the right side of the
door; hinges will be i_stalled <m the left
side of the case.
1, Remo_e the door stop and cam riser on
the oHgh_al bottom right side of the door.
2. Remo_e the fill plug ol_ the top right side
of the door.
3, Turn the door o_er aI_d reii_stall the
fill ph_g cm the i_ew left side.
To reinstall the door:
1, Install the original door stop and cam
riser ol_to the bottom left side of the
door.
2. Install the Ile_ st_pplied bottoI"_l case
hinge pin a_d bracket <into bottom
left side.
hlstall _,
3 Hinge _ ,
Screws ;
Remove
TopHinge
Hinge
Bracket
Remove
Hinge
3. Place the door o_to the bottom case
hi n ge.
4. Install the supplied left-hand top case
hi_ge _ith the 3 origi_al screws.
_. Select the hi_ge cover marked with
6, Peel backi_g off the tape il_side the
decorative hinge coxer.
7_
8_
Press a_d snap the InstallCovers
hinge co_er h_to
pl ace. A°"
S,_ap the screw hole _//
co_er into place (m
the opposite side.
_mportant: Check to be sme screx_s are
tight and that the door is straight and does
_ot sag. The door should swing fkeel_.
NOTE: See I_stallation Instrt_cticms to
apply binge coxer and screv, hole coxer.
Position nameplate:
Apply the Monogram l_ameplate o_ the
door usi_g the template incl t_ded i_ the
installaticm instru(tions.
13