JIlnstallation J Gas Slide-In RangeJ
nstructions PGS908, PGS975
I_ Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com I
I
In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
I
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a
licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
• A flexible gas connector, when used, must
not exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Savethese
instructions for local inspector's use.
• IMPORTANT - Observeall
governing codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these
instructions for future reference.
• Product failure due to improper installation
is not covered under the Warranty.
-_WARNING - This appliance must
be properly grounded.
• IMPORTANT - Leak testing of the
appliance shall be conducted according to
the manufacturer's instructions.
• Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
31-10642-1 03-07 JR
PARTS INCLUDED
Rear Filler
2 Screws
Screws
Anti-Tip Bracket
MATERIALS YOU MAY NEED
Joint Sealant Shut Off Valve
Pipe Fittings
CSA-Approved Flexible Gas Line
3/8" Min. ID, 1/2" NPT Connection,
3-foot Maximum Length (Massachusetts Only)
TOOLS YOU WiLL NEED
1/4" Nut Driver Level
Phillips Head
Screwdriver
Pipe Wrench
Flat-blade
Screwdriver Wrench or Pliers
(for 1-7/16" Nut)
Tape Measure Drill
Safety Glasses
To Next Page
Need help?
General