GE Spacemaker WSLS1100H User Manual

13
Hose Connector
Locking Collar
Uni-Coupler Hose
Faucet Connector
Drain Connection
COLD Water
Supply Connector
Water Filter
Installation Instructions
WASHER CONNECTIONS FOR PORTABLE MODEL
WSLP1100—ONE-FAUCET CONNECTIONS
REMOVE THE UNI-COUPLE
®
HOSE FROM INSIDE THE
WASHER BASKET
1
CONNECT TO WATER LINE
2
Use the hose connector provided with the washer for a
one-faucet connection.
TO CONNECT THE WASHER:
Attach the hose connector to the faucet adapter by
pulling down on the locking collar while lifting up
on the connector until it snaps into place. Make
sure the water filter provided is in place.
CONNECT TO VALVE INLET
3
Attach the COLD water supply connector to the
COLD water valve inlet (color BLUE). Make sure
the washer is inside the connector before
tightening.
TIGHTEN CONNECTOR
4
Tighten the connector, ensuring the threads are
aligned properly for tightest fit. Inspect for kinks
or binding of the hose.
NOTE: Do not remove the plastic cap from the HOT
water inlet for uni-coupler connections as leakage may
occur.
Plastic Cap
CONNECT DRAIN HOSE
5
Attach the drain hose to the rear of the washer.
Install the clamp on the drain hose and tighten
to prevent leakage of water.

GE Spacemaker WSLS1100H Specifications

General

Brand	GE
Model	Spacemaker WSLS1100H
Category	Washer
Language	English