General Electric
Moist ‘nFresh Drawer
The fill-width top drawer is
Fred-Saver System
designed to keep unwrapped foods
fresh by retaining the natural *
moisture content of foods such as:
● A~Cho~s
● Cherries
● plums
cA3paragus
● Corn
● Radishes
● w, topped ● cunants
● Rhubarb
● Blueberries
● Greens,leafy● Spinach
● cam
● IAtuce
● TOm~oes,
● cele~
● Pmley
ripe
● Peas,green
As in any refrigerated storage area,
it is recommended that odorous
foods be
StOred Wrapped-fds
such as:
● Broccoli
. c~bage
● Parsnips
● B~e~
● cau~fl~r
● TUm@
sprouts
● G~n onions
Storage time will depend upon the
type of fd and its condition when
placd in the drawer.
Excess water which may accumulate
in the bottom of the Moist ‘nFresh
drawer should be poured out and
the drawer wiped dry.
The Moist ‘nFresh drawer is
partially sealed by gaskets attached
to the cover at the front and back
edges. Always push the drawer all
the way in.
ConvertibleMeat Keeper
The Convertible Meat Pan drawer
has its own cold air duct to allow a
stream of cold air from the freezer
compartment to flow around the
drawer.
The variable temperature control
regulatesthe air flow fromthe
freezercompartment.
Moist ‘n Fresh
drawer-
c/osetightly —
Convertible
Meat Keeper—
IHIJ
Uk41
Drawer Removal
Set control lever to MEAT–the
coldest setting-to store fresh meats.
If lever is left in meat position for a
long period of time, some frost may
form on the inside of the drawer.
Set control lever to VEG to convert
the drawer to normal refrigerator
temperature and provide extra
vegetable storage space. Cold air
duct is turned off.
Variable settings between these
extremes can be selected.
\
Drawers will stop before coming all
the wayout of refrigerator to help
prevent contents from spilling onto
floor. Drawm can easilybe removed
by tilting up slightly and pulling
past “stop” location.
To remove drawers when the
fresh food compartment door
cannot be opened fully:
1. Remove fd from the shelf
abovethe Moist ‘nFresh drawer and
take out the shelf. Take fd off of
the glass coverand out of the drawer.
2. Removethe flexible gasketat
therearof theMoist’nFreshdrawer.
Lifi each end straight up until the
slots on the gasket are free of the
drawer support tabs.
J
,’”” )
*.” ,?
/’
10
. . .... . ...,
... ./
-r”
.,
,.
.,, ,-,
..,. ,
To Next Page
Loading...
Need help?
General
