Introduction
When ordering service parts, specify the correct part
number, full description, quantity required, the unit
model number and serial number.
The model and serial numbers for this unit are on a
Decal located inside the right Chassis Riser, between
the Lift Arm and Lift Cylinder. “Right” and “Left” are
determined from a position sitting on the Seat and fac-
ing forward.
GEHL
Company reserves the right to make changes
or improvements in the design or construction of any
part of the unit without incurring the obligation to
install such changes on any previously delivered units.
NOTE:
On original tire replacement, Company
policy prohibits the sale of replacement tires for all
GEHL machinery. Replacement Wheel Sets are
available and tire size information is called out
with the Wheel Sets to facilitate replacement tire
selection. ALL REPLACEMENT TIRES MUST BE
PURCHASED LOCALLY.
NOTE:
Replacement batteries are not provided
by the GEHL Company. For battery specifications
see pages titled “Battery & Engine Electrical Wir-
ing.” ALL REPLACEMENT BATTERIES MUST BE
PURCHASED LOCALLY.
Refer to the abbreviations table located on this page for
the various fastener descriptions. Standard attaching
hardware torque values are also provided on the inside
back cover.
Items shown in the parts list that do not have Reference
Numbers are shown for reference purposes only and
are NOT available for purchase.
Unless otherwise specified, all Cap Screws or Bolts are
Grade 5, cadmium or zinc plated; Hexagon Nuts for
Grade 5 Screws or Bolts are Grade B; Hexagon Nuts
for other Screws or Bolts are Grade A.
Refer to the Operator’s manual for additional informa-
tion regarding GEHL attachments and accessories.
NOTE:
The following abbreviations may be used
herein:
A/C - Air Cleaner
AR - As Required
ASSY - Assembly
C5Z - Class 5 Zinc Plated
CB - Carriage Bolt
CS - Cap Screw (Hexagon Head)
CYL - Cylinder
DEG - Degree
FW - Flat Washer
GR - Grade
HHC - Hex Head Cap Screw
INT - Internal
JIC - Joint Industry Conference
L - Lock Washer
LN - Lock Nut
LT - Left
MM - Millimeter
N - Nut (Hex Head)
N/A - Not Applicable
NEG - Negative
NILN - Nylon Insert Lock Nut
NF - National Fine
NPT - National Pipe Thread
P - Plain Washer
PBY - Power Beyond
PL - Plain
POS - Positive
REF - Reference
RHMS - Round Head Machine Screw
ROPS - Roll-Over Protective Structure
RT - Right
SHCS - Socket Head Cap Screw
SHSS - Socket Head Set Screw
SN - Serial Number
SQ - Square
STR - Straight
T- Teeth
TCS - Thread Cutting Screw
TFS - Thread Forming Screw
THMS - Truss Head Machine Screw
THRD - Thread
UNC - Unified National Coarse (Thread)
UNF - Unified National Fine (Thread)
To Next Page
Loading...
Need help?
General
