Gemini XGA-5000 User Manual

3
PRECAUTIONS
1. All operating instructions should be read before using this equipment.
2. To reduce the risk of electrical shock, do not open the unit. There are NO USER REPLACEABLE PARTS
INSIDE. Please refer servicing to a qualified Gemini service technician. Do not attempt to return this
equipment to your dealer.
3. Do not expose this unit to direct sunlight or to a heat source such as a radiator or stove.
4. This unit should be cleaned only with a damp cloth. Avoid solvents or other cleaning detergents.
5. When moving this equipment, it should be placed in its original carton and packaging. This will reduce
the risk of damage during transit.
6. DO NOT EXPOSE THIS UNIT TO WATER OR HEAT.
7. DO NOT USE CLEANING PRODUCTS OR LUBRICANTS ON THE CONTROLS OR SWITCHES.
PLEASE READ CAREFULLY BEFORE PROCEEDING
Always follow the basic precautions listed below to avoid the possibility of serious injury or even death
from electrical shock, short-circuiting, damages, fire, or other hazards.
• READ INSTRUCTIONS - All the safety and operating instructions should be read before the product is
operated.
• RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference
All the safety and operating instructions should be read before the product is operated.
• HEED WARNINGS - All warnings on the product and in the operating instructions should be adhered to.
• FOLLOW INSTRUCTIONS - All operating and use instructions should be followed.
• CLEANING - The product should be cleaned only with a polishing cloth or a soft dry cloth. Never clean
with furniture wax, benzine, insecticides or other volatile liquids since they may corrode the cabinet.
• WATER AND MOISTURE - Do not use this product near water, for example, near a bathtub, wash bowl,
kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.
• DO NOT OPEN - Do not open the device or attempt to disassemble the internal parts or modify them in
any way. The device contains no user- serviceable parts. If it should appear to be malfunctioning,
discontinue use immediately and have it inspected by qualified GEMINI service personnel.
• REPLACEMENT PARTS - When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
• VENTILATION - The XGA amplifier should be situated so that its location or position does not interfere
with its proper ventilation. For example, the Component should not be situated on a bed, sofa, rug, or
similar surface that may block any ventilation openings, or placed in a built-in installation such as a
bookcase or cabinet that may impede the flow of air through ventilation openings
• CONNECTIONS - Before connecting the device to other devices, turn off the power for all devices.
Before turning the power on or off for all devices, set all volume levels to minimum.
- Use only speaker cables for connecting speakers to the speaker jacks. Use of other types of cables may
result in fire.
- Be sure to observe the amplifier’s rated load impedance, particularly when connecting speakers in
parallel. Connecting an impedance load outside the amplifier’s rated range can damage the amplifier.

Gemini XGA-5000 Specifications

General

Amplifier class	-
Frequency range	10 - 50000 Hz
Input sensitivity	770 mV
Audio output channels	2.0 channels
Peak power per channel	5000 W
Signal-to-Noise Ratio (SNR)	100 dB
Total Harmonic Distortion (THD)	0.1 %
Dynamic power per channel (4 Ohm)	550 W
Dynamic power per channel (8 Ohm)	400 W
Bridge-mode power output per channel (8 Ohm)	1100 W
Purpose	Performance/stage
Cooling type	Active
On/off switch	Yes
Product color	Black
Volume control	Rotary
Connectivity technology	Wired
Power protection features	Short circuit
Audio (L/R) in	2
LED indicators	Clipping, Y

Weight and Dimensions

Depth	350 mm
Width	482 mm
Height	88 mm
Weight	10620 g