CONNECTIONS
1. Power Switch: Powers on the unit.
2. Channel 1/Channel 2 Volume Knob: Adjusts volume of amplifier.
3. XLR and 1/4” Input: Amplifier inputs.
4. Mode Switch: This switch controls the amplifier’s operating mode. The amplifier can
operate in two different modes; Mono Bridge or Stereo.
5. Ground Switch: This switch allows the ground signal or chassis ground to be separated
in case of a ground conflict. For the safety of the amp, it is recommended to keep the
switch in the GND FLOATING position. In case of a ground conflict please set the switch
to GND LIFT.
6. Speakon Output: Optional speaker output connections. Use pins 1+ and 1- of this 4-pole
Speakon connector to connect to your speaker’s Speakon input jack.
7. Bridge and Ground Connections: Connect to your speaker’s input jack. Red is positive
signal and Black is negative signal. When using Bridge Mode, use Channels 1 & 2 positive
connectors (Red).
Note: In Bridge (Mono) mode, CH2 input is used. Audio connected to CH 1 will not get
routed to speaker output.
8. Power Cord Receptacle: Plug your power cable in here
To Next Page
Loading...
Need help?
General
