The table below details the five function options available to you in Setup
mode.
Function Option No. Setting Action
(Left Digit) (Right Digit)
Default 0 0 Loads factory default settings
Settings 1 Loads user’s default settings
Source Backlight comes on for 30 seconds
Beeper 1 0 Programs beeper to beep faster the higher the
moisture level above 17%WME (17 in REL mode)
1 Programs beeper to beep faster the higher the
moisture level
2 Programs beeper to sound when switching
between measurement modes
3 Disables beeper. Removes icon from display
Auto power 2 0 Disables auto power off function
off 1 Sets auto power off interval to 3 minutes
2 Sets auto power off interval to 5 minutes
3 Sets auto power off interval to 10 minutes
Backlight 3 0 Disables display backlight
1 Enables display backlight
Calibration 4 0 Enables manual calibration checking by user
Check 1 Programs meter to automatically check its
calibration each time it is powered on
The factory default setting for all five functions—including the source of the
default settings—is 0.
To change any or all settings to your choice(s), you must first change the
setting of Option 0 from 0 to 1. Opportunities to change the settings of the other
four functions from their factory defaults are then made available in order, from
Option 0 to Option 4. As each Option is presented, you can change its setting
or leave the existing setting unchanged. In either case, you must confirm the
setting to allow the sequence to continue.
It’s important to understand that in Setup mode you have 30 seconds to
confirm the setting of each Option. If you take longer than 30 seconds to
confirm any setting, the MMD950 will automatically exit Setup mode and enter
Measurement mode.
8
To Next Page
Loading...
Need help?
General
