English
- 1 -
Hardware Installation
1. Install one AA or AAA battery in the mouse as instructed.
2. Make sure that you have switched on the power switch underneath the mouse.
Mouse Button Assignments
1. Left Button: Provides traditional mouse functions like
click, double click and drag.
2. Magic-Roller: Press the “Magic-Roller” to surf the
Internet and Windows documents.
3. Right Button: Provides traditional mouse click functions.
4. Switch Device Button: Press this button to switch
between PC or tablet device.
Note: Download the programmable driver from our website:
www.geniusnet.com
Warning: (Troubleshooting)
1. Do not use the wireless optical/laser mouse on a desk
which is made of glass or mirror.
2. The connection of the wireless device is factory preset,
so when you plug the USB receiver into any USB port,
the connection between the micro receiver and the mouse will be established
automatically.
3. In case your PC did not install the hardware successfully, remove the micro receiver from
the USB port and go Human Interface Devices under Device Manager to remove the
mouse then plug in the micro receiver to a USB port again.
4. If you feel the mouse does not move smooth as usual, it is possible the battery has lost its
charge so you need to replace it. Remember to put the battery in the correct direction.
To Next Page
Need help?
General
