Universal Remote-Control JJ-RC-SM24 Instructions
Please read the instructions thoroughly BEFORE beginning setup. The universal remote control can be used to
activate up to two devices such as garage door openers and/or gate openers, and each button of the remote can be
set to a different version of control if needed see compatibility list below.
1. Start with the gate or garage door closed.
2. Determine if your opener uses a learn button to add a remote or if it uses code switches (See Compatibility List).
3. Remove the access cover of the remote by sliding it off in the direction of the arrow giving access to the program
button and code switches (Fig1).
Programming for code switch systems:
4. Match the code switches in the remote to the
same on/off positions as the working remote or
radio receiver.
5. Press and hold the program button on the
remote until the LED indicator light comes on (about
two seconds) then release the button (Fig 2).
6. Press and release the button you wish to use on
the remote, pausing between presses until the
indicator light stops flashing the opener activates,
press and release the program button on the remote
so it memorizes the setting.
7. Repeat the process for the second button, if
need, using the code switch or learn button
instructions used for that device.
8. Test the remote to verify that it is working
correctly and then slide the access cover back into
place.
Programming for learn button systems:
4. Locate the learn button on your gate or garage
door opener.
5. Press and hold the program button on the
remote until the LED indicator light comes on (about
two seconds) then release the button (Fig 2).
6. Press and release the learn button on the opener
so the indicator light comes on.
7. Press and release the button you wish to use on
the remote, pausing between presses, so the
indicator light stops flashing until:
A) There is a click from the opener
B) The openers light comes on or flashes
C) The LED indicator light on the opener comes
on solid if it was flashing or flashes if it was sold
D) The opener activates.
8. Then press and release the program button on the
remote so it memorizes the setting.
9. Repeat the process for the second button, if
need, using the code switch or learn button
instructions used for that device.
10. Test the remote to verify that it is working
correctly and then slide the access cover back into
place.
WARNING
To prevent possible SERIOUS INJURY or DEATH from a
moving gate or garage door:
• ALWAYS keep remote controls out of reach of
children. NEVER permit children to operate or play
with remote control transmitter
• Activate gate or door ONLY when it can be seen
clearly, is properly adjusted and there are no
obstructions to door travel
• ALWAYS keep gate or garage door in sight until
completely closed. NEVER permit anyone to cross
path of moving gate or door.
Fig 1. Fig 2.
To Next Page
Need help?
General
