BIOS Setup - 32 -
PAVP Lite Mode
This item is congurable only if the PAVP Mode option is set to PAVP Lite Mode.
Options are: 32MB (default), 48MB, 64MB, 128MB and 256MB.
Paranoid PAVP Mode
This item is congurable only if the PAVP Mode option is set to Paranoid PAVP.
Options are: (32+96)128MB (default), (48+96) Round to 160MB, (64+96)160MB, (128+96)224MB and
(256+96)352MB.
The table below shows the supported features of the PAVP Lite and Paranoid PAVP modes.
Feature PAVP Lite Paranoid PAVP
Compressed video buffer is encrypted Yes Yes
Hardware 128-bit AES decryption Yes Yes
Protected memory No Yes
(96 MB reserved during boot)
2-7 Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
On-Chip Primary PCI IDE [Enabled]
On-Chip SATA Mode [Auto]
x PATA IDE Set to Ch.0 Master/Slave
SATA Port 0/2 Set to Ch.2 Master/Slave
SATA Port 1/3 Set to Ch.3 Master/Slave
Azalia Codec [Auto]
Onboard H/W LAN [Enabled]
Green LAN [Disabled]
SMART LAN [Press Enter]
Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
USB 1.0 Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
USB Storage Function [Enabled]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
On-Chip Primary PCI IDE
Enables or disables the rst integrated IDE controller. (Default: Enabled)
On-Chip SATA Mode
Congures the integrated SATA controller.
Disabled Disables the integrated SATA controller.
Auto Lets the BIOS set SATA devices to Combined or Enhanced mode.
If your onboard SATA controller is automatically congured to Combined mode,
you can manually re-congure it to Enhanced mode as needed. (Default)
Combined Sets all SATA devices to operate in PATA mode. Combined allows a
maximum of 4 ATA devices to be used simultaneously: two PATA devices
plus two SATA devices.
Enhanced Sets all SATA devices to operate in SATA mode.
Non-Combined Sets all SATA devices to operate in PATA mode and disables the integrated
IDE controller.