Name: Go Power GP-SW
Brand: Go Power
Rating: 5 (1 reviews)

To Previous Page

GP-SW Remote

_____________________________________ _______________________________________________________________



Step 3- Continue using the remote only to turn the inverter ON and OFF.

5.0 Mounting the Remote

Step 1- Cut out the template attached and position it on the wall where the remote is to be mounted.

Step 2- Mark the location of the two holes, and the square area to be cut out. Note: Remote switch assembly requires 0.7” (18mm)

minimum clear panel depth.

Step 3- Drill two holes, 7/64” (2.8mm) diameter and remove the cutout area.

Step 4- Feed the connector and wire though the cutout hole in the panel and route the wire to the inverter receptacle (RS 232 Port).

Step 5-Position the remote switch assembly upright and secure to the panel using the two screws provided. Plug the phone jack into the

inverter. Press the button to turn the inverter on and off.

6.0 Mounting Template



CARMANAH BATTERY

CAR BATTERIES

Questions and Answers:

Need help?

Do you have a question about the Go Power GP-SW and is the answer not in the manual?

Go Power GP-SW Specifications

General