Goodwe GW10K-DT Installation Guide

DEFAULT CONFIGURATION IN TRACKSO IOT GATEWAY
Inverter ID: 1, 2, 3, 4 …. Continuous numbering starting with 1, (Range: 1 to 247)
Baud Rate: 9600 (Default) (Values: 9600, 19200, 38400)
Data Bits: 8 , Stop Bit: 1 , Parity: None
CONFIGURATION AT THE INVERTER END
SETTING THE BAUD RATE
Default Baud rate for GoodWe Inverters is 9600bps.
SETTING THE INVERTER ID
The inverter ID is used to identify the inverter in a RS485 connection
 Set a different inverter ID for each inverter in the PV plant. Otherwise, the inverters cannot be correctly
identified.
 On the last inverter in the RS485 connection, switch on the RS485 termination resistor.
SET DATE & TIME OF INVERTER
For a precise calculation of the statistics in the inverter itself and in a monitoring system, date and time have to be
correct.
 Set the Correct Date & Time
 Set correct Inverter Ids

Goodwe GW10K-DT Specifications

General

Brand	Goodwe
Model	GW10K-DT
Category	Inverter
Language	English