2 309400
4. Push the new electrode (G) through the air cap hole.
Make sure the short end (BB) of the electrode
engages the hole (CC) in the back of the air cap.
Press the electrode in place firmly with your fingers.
Fig. 2. Electrode Replacement
5. Install the air cap assembly.
6. Test gun resistance by measuring the resistance
between the electrode needle tip (G) and the air
swivel (H); it should be 156-180 megohms. See Fig.
3. If outside this range, test the power supply resis-
tance as instructed in your separate gun manual.
Fig. 3. Test Gun Resistance
Graco Phone Numbers
TO PLACE AN ORDER, contact your Graco distributor, or call one of these numbers
to identify the distributor closest to you:
1-800-367-4023 Toll Free
612-623-6921
612-378-3505 Fax
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Sales Offices:
Minneapolis, Detroit
International Offices:
Bel
ium, Korea, Hon
Kon
, Japan
*5$&2 ,1& 32 %2; 0,11($32/,6 01
www.graco.com
PRINTED IN USA 309400 10/2001
02013
BB
CC
G
TI1469A
H
G
To Previous Page
Loading...
Need help?
General
