EN - 24
Each Use
Check Tires See Specifications on page 43 for correct tire
pressure.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is possible
when they are serviced incorrectly:
• Do not attempt to mount a tire without the
proper equipment and experience to perform
the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and tire assembly.
Heat can cause an increase in air pressure
resulting in an explosion. Welding can
structurally weaken or deform the wheel.
• Do not stand in front or over the tire assembly
when inflating. Use a clip-on chuck and
extension hose long enough to allow you to
stand to one side.
Clean Unit Clean engine, battery, seat, mower deck, etc. of dirt
and debris. Do not use solvents, hard cleaners, or
abrasives.
NOTICE: Protect painted surfaces with automotive
type wax.
IMPORTANT: Do not spray the unit with water,
especially when the unit is warm from operation.
Water can seep into bearings and damage them.
Follow Engine Manual
Maintenance Schedule
Perform scheduled engine maintenance. Refer to
engine manual for detailed instructions.
Every 25
Hours
Check Mower Blades Check mower blades for wear. Sharpen or replace as
needed.
See Carbon Canister Filter on page 28.
Every 50
Hours
Check Air FIlter Check air filter for dirt. Clean as required. Follow
Engine Manual for maintenance schedule.
Lubricate Unit Oil all pivot points and pin connections. Grease lube
fittings. See ELECTRICAL SERVICE on page 30.
Check Brake Gap Adjust gap if necessary. See Adjusting the Parking
Brake on page 33.
Every
100
Hours
Clean Battery Keep battery and its terminals clean. See Clean
Battery on page 29
.
Clean engine cooling
system
Check and clean cooling fins and inside the engine
shrouds to remove grass, chaff or dirt.
Check Fasteners Check mower blade mounting hardware and all other
fasteners. Replace missing or damaged fasteners.
Tighten all nuts and bolts to their correct torque value.
Check Belts Replace worn or deteriorated belts. See Replacing
Mower Belts on page 34 and Replacing the Hydro
Pump Belt on page 36.
Every
400
Hours
Change Hydraulic Fluid
and Filter
*
Drain hydraulic fluid tank, replace hydraulic oil filter,
refill system. See Hydraulic Fluid on page 26.
Period Service Task
To Next Page
Loading...
Need help?
General
