23
Remove Collected Water: Continuous
Drainage Middle Hole Option
1
2
Remove the Continuous Drain Cap by turning it
counter clockwise, then remove the
Rubber Plug
from the spout.
Screw the
Drain Connector (included in the
package) to the spout by turning clockwise.
Insert the
Drainage Hose into the Drain
Connector
.
NOTICE:
Water can automatically empty into a floor drain by attaching a garden hose (not included).
ATTENTION:
When using continuous drainage option from the middle hole, place portable on a level
surface and make sure garden hose is clear of any obstructions and is directed downward. Placing portable on an
uneven surface or improper hose installation may result in water filling up the chassis and causing the unit to shut
off. Empty water in the chassis if shut off occurs, then check portable location and hose for proper setup.
CLEANING AND MAINTENANCE
Middle Hole
NOTICE:
This picture is for reference only. Please refer to the actual product for the appearance.
To Next Page
Loading...
Need help?
General
