Method 2: Drain water through drain hose
This unit is connect with drain outlet. User can purchase the drain hose whose
inner diameter is 14mm (length is 1.3-1.5m) and assemble it on the drain adapter
to drain water. when you are going to assemble the continuous drain equipment,
Turn off the unit and pull out the power plug.
1.
Open continuous drain outlet and then remove the drain cover along the
arrow direction as shown in below arrow.
2.
Remove the drainage choke plug at first, rotate the drainage adapter into the
continuous drain outlet in clockwise direction.
Pull the drainage adapter through the continuous drain outlet, and then rotate it
into the drain outlet tightly. Please check whether the gasket is in good condition.
Note:
When using the water tank to drain water, please re-assemble the drain cover
and the drainage choke plug. Otherwise, leakage may occur when using water
tank to drain water.
9
drain cover
drainage
choke plug
drainage
adapter
Note:
After removing the drainage choke plug, there will be a little residual condensate
water. Please use container to collect for preventing the floor get moisture.
To Next Page
Loading...
Need help?
General
