8
6.2. Selecting the channel/Other measuring stations
Note
• You can connect up to three different base stations to the
measuring station. Ensure that the base station and measuring
station are set to the same channel. Suitable base stations can be
found at www.hama.com
• The transmission channel on the supplied measuring station can
be changed/set (CH1, CH2, CH3).
• The measuring station is suitable for the following base stations:
113984, 113985, 113986
6.3. Low battery charge
Once the battery symbol appears on the display of the base station,
the capacity of the batteries in the measuring station is very low. Replace
the batteries immediately.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each time after
you change the batteries in the measuring or base station.
• To do this, remove the batteries from the other station and then
reinsert them, or change them as required.
To Next Page
Loading...
