AVR 445 SETTINGS WORKSHEETS
SYSTEM DEFAULTS
The table in this section shows the factory default settings for all inputs to give you a picture of the AVR 445’s initial settings. You may then decide
whether any item needs to be changed so that it is more appropriate for your specific installation. Any of the settings shown may be changed as shown
in the System Configuration section of the owner’s manual.
TABLE 1: INPUT DEFAULTS
INPUT AUDIO VIDEO COMPONENT RECORD
INPUT INPUT VIDEO INPUT OUTPUT
Video 1 ANALOG AUTO OFF ANALOG
Video 2 ANALOG AUTO OFF ANALOG
Video 3 OPTICAL 1 AUTO COMPONENT 1 ANALOG
Video 4 ANALOG AUTO COMPONENT 2 ANALOG
DVD COAX 1 AUTO COMPONENT 3 ANALOG
HDMI 1 OPTICAL 3 HDMI 1 --- DSP DOWNMIX
HDMI 2 COAX 3 HDMI 2 --- DSP DOWNMIX
Tuner ANALOG AUTO OFF ANALOG
XM --- AUTO OFF ANALOG
CD ANALOG AUTO OFF ANALOG
Tape ANALOG AUTO OFF ANALOG
DMP/The Bridge ANALOG AUTO OFF ANALOG
6/8 CH Direct ANALOG AUTO OFF ANALOG
USB --- AUTO OFF DSP DOWNMIX
System Default and Personal Settings Worksheets
The worksheets in this section show the system defaults for the global settings on your AVR 445. Once your system is configured manually, or
through the use of EzSet/EQ II, where applicable, we recommend that you use the “Your System Settings” column to record your personal preferences
so that they may be restored in the event the AVR’s memory is lost due to an extended power outage, system upgrade, processor reset, or
other major service to your unit.
Worksheet A: Surround Configuration Defaults and Settings
Feature System Default Your System Settings
Logic 7 Global Off
Default Surround Original
Dolby Pro Logic II Music Center Width 3
Dolby Pro Logic II Music Dimension 0
Dolby Pro Logic II Music Panorama Off
Dolby Pro Logic IIx Music Center Width 3
Dolby Pro Logic IIx Music Dimension 0
Dolby Pro Logic IIx Music Panorama Off
Night Mode Off
AVR445WebDiagrams-SttgsWkSht 7/21/06 4:25 PM Page 1
To Next Page
Need help?
General
