Spray arms
Make sure that the spray holes are not clogged and that no food waste or foreign object is
stuck to the spray arms. If there is any clogging,remove the spray arms and clean them under
water. To remove the upper spray arm undo the nut holding it in position by turning it
clockwise and pulling it downwards. Make sure that the nut is properly tightened when
refitting the upper spary arm.
Drain Pump
Large food residues or foreign objects which were not captured by the filters may block the
waste water pump. The rinsing water will then be above the filter.
Warning Risk of cuts!
When cleaning the waste water pump, ensure that you do not injure yourself on pieces of
broken glass or pointed implements.
In this case:
1. First always disconnect the appliance from the power supply.
2. Take out baskets.
3. Remove the filters.
4. Scoop out water, use a sponge if required.
5. Check the area and remove any foreign objects.
6. Install filters.
7. Re-insert baskets.
To Next Page
Loading...
Need help?
General
