HELIX V TWELVE DSP MK2 User Manual

44
ACO platform features
Beside the unique DSP sound e󰀨ects the
V TWELVE DSP MK2 provides a bunch of new sys-
tem features.
In the DCM menu of the DSP PC-Tool software in-
dividual settings can be made for several of these
system features.
Turn On & O󰀨 Delay
This function allows to determine the delay time
with which the integrated DSP is switched on and
o󰀨. The factory setting is 0.2 seconds. The delay
time should only be modied if there are e.g. noises
while switching on / o󰀨 the amplier.
URC Setup Switch Conguration
The ACO provides ten internal memory locations for
sound setups instead of the common two.
By using an optional URC remote control or the Con
-
trol pushbutton it is possible to toggle between two
of the ten memory locations. These two memory lo
-
cations can be determined in the “URC Setup Switch
Conguration”. The memory locations one and two
are preassigned by default. To switch between all
internal memory locations, the optionally available
remote controls DIRECTOR and CONDUCTOR or
the HELIX WIFI CONTROL are / is recommended.
Remote Output Conguration
This function controls if the remote output (which
switches on and o󰀨 the connected ampliers) will
be temporarily deactivated during a sound setup
switch. This function is activated (ON) by default.
ADEP.3 Conguration
If the V TWELVE DSP MK2 is connected to an
OEM radio via the highlevel inputs it may happen
that the ADEP.3 circuit has to be adapted to the di-
agnostic mode of the radio if the latter is equipped
with a so-called “class SB” output stage”.
The ADEP.3 circuit should be adjusted if there are
e.g. distortions in the upper volume range.
The compatibility mode is disabled by default.

HELIX V TWELVE DSP MK2 Specifications

General

Brand	HELIX
Model	V TWELVE DSP MK2
Category	Amplifier
Language	English