3
wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician, DO NOT attempt to defeat this safety feature.
Note:
1. A short power supply cord (or detachable power supply cord) should be used
to reduce the risk resulting from becoming entangled in, or tripping over, a
longer cord.
2. Longer detachable power supply cords or extension cords are available and
may be used if care is exercised in their use.
3. If a longer detachable power supply cord or extension cord is used.
The marked electrical rating of the cord set or extension cord should be at
least as great as the electrical rating of appliance; and
The cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on by children or tripped over
unintentionally.
START UP
1. Carefully unpack the popcorn maker and all the accessories from gift box. Please verify
that you have all the following accessories before recycling the gift box.
User manual
Measuring Scoop (2 oz Capacity)
2. Before first use, you should clean the unit carefully. Remove anything inside the popping
chamber. Wipe the popping chamber with a soft cloth slightly dampened with water. Let it
dry thoroughly.
Note: Never immerse the popcorn maker in the water or other liquid.
3. Fill the included Measuring Scoop with approximately 2 oz of kernels until it is LEVEL.
4. Open the Cover Lid.
5. Pour kernels into the Popping Chamber. Do not put oil or any other ingredients into
Popping Chamber
.
6. Be sure that the
Cover Lid
is closed properly.
7. Put a large heat resistant bowl under the Popping Chute to collect the popcorn.
8. Plug the popcorn maker into a 120V household AC outlet and put the Power Switch to
“On” position to turn on. The popcorn will be ready in about 2-3 minutes. When the corn
has stopped popping, put the Power Switch to “Off” position to turn it off.
9. Before popping more batches of popcorn, make sure the popcorn maker is allowed to
cool down for 10-15 minutes. Using heat resistant gloves, remove any unpopped
kernels from popping chamber. If necessary, unplug the unit from the AC power outlet.
Turn the unit upside down and shake the popcorn maker slightly to remove popcorn or
unpopped kernels inside the popping chamber.
10. For more batches of popcorn, plug in the unit again and repeat steps #3 thru #8 above.
11. Unplug the unit when all popping is complete. Always remove popcorn or unpopped
kernels inside the
Popping Chamber
.
Note:
Maximum capacity of kernels for each batch is 2 oz.
To Next Page
Loading...
Need help?
General
