8. Fit the bubble back to the camera.
Figure 2-11 Fit the Black Liner Back
9. Tighten the screws on the bubble of the dome camera
to finish the installation.
Figure 2-12 Finish Installation
2.4 Wall Mounting of Type III Camera
Before you start:
You need to purchase a wall mount first.
Steps:
1. Drill 4 screw holes in the wall according to the holes of
the mount.
2. Attach the mount to the wall by aligning the 4 screw
holes of the mount with expansion screws on the wall.
3. Secure the mount with 4 hex nuts and washers.
Figure 2-13 Install Wall Mount
4. Refer to step 3 of 2.3 Ceiling Mounting of Type III
Camera to remove dome camera’s bubble.
5. Attach the back box of the dome camera to the wall
mount, and secure them with supplied screws.
Figure 2-14 Attach the Back Box to the Mount
6. Route the cables through the mount.
7. Repeat steps 6 to 9 of the 2.1 Ceiling Mounting of Type
III Camera to complete the installation.
To Next Page
Loading...
Need help?
General
