30
battery information. The battery is marked with this symbol,
which may include lettering to indicate cadmium (Cd), lead
(Pb), or mercury (Hg). For proper recycling, return the battery
to your supplier or to a designated collection point. For more
information see: www.recyclethis.info.
According to the Batteries and Accumulators (Placing on the
Market) Regulations 2008 and the Waste Batteries and
Accumulators Regulations 2009: This product contains a
battery that cannot be disposed of as unsorted municipal
waste in the United Kingdom. See the product documentation
for specific battery information. The battery is marked with
this symbol, which may include lettering to indicate cadmium
(Cd), lead (Pb), or mercury (Hg). For proper recycling, return
the battery to your supplier or to a designated collection
point. For more information see: www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-003 (A) / NMB-003 (A)
standards requirements.
Cet appareil répond aux exigences des normes CAN ICES-003
(A)/NMB-003 (A).
KC
A급 기기: 이 기기는 업무용(A급) 전자파적합기기로써
판매자 또는 사용자는 이 점을 주의하시기바라며, 가정
외의 지역에서 사용하는 것을 목적으로 합니다.
Warning
This is a class A product. In a domestic environment this
product may cause radio inter-ference in which case the user
may be required to take adequate measures.
Safety Instruction
Warnings
Laws and Regulations
The device should be used in compliance with local laws,
electrical safety regulations, and fire prevention regulations.
Electrical Safety
CAUTION: To reduce the risk of fire, replace only with the
same type and rating of fuse.
This equipment shall be installed incorporated with UPS to
avoid the risk of restart.
Battery
This equipment is not suitable for use in locations where
children are likely to be present.
CAUTION: Risk of explosion if the battery is replaced by an
incorrect type.
Improper replacement of the battery with an incorrect type
may defeat a safeguard (for example, in the case of some
lithium battery types).
Do not dispose of the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may result in an
explosion.
Do not leave the battery in an extremely high temperature
surrounding environment, which may result in an explosion
or the leakage of flammable liquid or gas.
Do not subject the battery to extremely low air pressure,
which may result in an explosion or the leakage of flammable
liquid or gas.
Dispose of used batteries according to the instructions.
For Device with Laser
Only professionals can operate the device with laser module.
DO NOT stare at operating light source. May be harmful to
the eyes.
If appropriate shielding or eye protection is not available, turn
on the light only at a safe distance or in the area that is not
directly exposed to the light.
When assembling, installing or maintaining the device, DO
NOT turn on the light, or wear eye protection.
Warning: This sticker is to indicate that the laser radiation
emitted from the device can cause eye injuries, burning of
skin or inflammable substances. Before enabling the Light
Supplement function, make sure no human or inflammable
substances are in front of the laser lens. Do not place the
device where minors can fetch it.
Laser Class 2 Information
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Laser Class 3B Information
Wavelength: 810 nm
Beam Divergence: 6°/12°
Max. Output: 500 mW
MPE at NOHD (Nominal Ocular Hazard Distance) (11 m): 0.04
mW
Cautions
Fire Prevention
No naked flame sources, such as lighted candles, should be
placed on the equipment.
The serial port of the equipment is used for debugging only.
Hot Surface
CAUTION: Hot parts! Burned fingers when handling the parts.
This sticker is to indicate that the
marked item can be hot and should
not be touched without taking care.
Wait one-half hour after switching off
before handling parts.
The device with this sticker is intended for installation in a
restricted access location. Access can only be gained by
service persons or by users who have been instructed about
the reasons for the restrictions applied to the location and
about any precautions that shall be taken.
Installation
Install the equipment according to the instructions in this
manual.
To prevent injury, this equipment must be securely attached
to the ceiling/wall in accordance with the installation
instructions.
Be sure that there is enough space to install the device and
accessories.
Make sure that the wall is strong enough to withstand at least
8 times the weight of the device and the mount.
Make sure that the power has been disconnected before you
wire, install, or disassemble the device.
Transportation
Keep the device in original or similar packaging while
transporting it.
Do not drop the product or subject it to physical shock.
Power Supply
The power source should meet limited power source or PS2
requirements according to IEC 60950-1 or IEC 62368-1
standard.
Refer to the device label for the standard power supply.
Please make sure your power supply matches with your
device.
Use a power adapter provided by qualified manufacturers. It
is recommended to provide an independent power adapter
for each device as adapter overload may cause over-heating
or a fire hazard.
System Security
Please understand that you have the responsibility to
configure all the passwords and other security settings about
the device, and keep your user name and password.
To Next Page
Loading...
Need help?
General
