Network Video Recorder User Manual
viii
Preventive and Cautionary Tips
Before connecting and operating your device, please be advised of the following tips:
● The device is designed for indoor use only. Install it in a well-ventilated, dust-free environment
without liquids.
● Ensure recorder is properly secured to a rack or shelf. Major shocks or jolts to the recorder as a
result of dropping it may cause damage to the sensitive electronics within the recorder.
● The equipment shall not be exposed to dripping or splashing and that no objects filled with
liquids shall be placed on the equipment, such as vases.
● No naked flame sources, such as lighted candles, should be placed on the equipment.
● The ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc. The openings shall never be blocked by placing the
equipment on a bed, sofa, rug or other similar surface.
● For certain models, ensure correct wiring of the terminals for connection to an AC mains supply.
● For certain models, the equipment has been designed, when required, modified for connection
to an IT power distribution system.
● identifies the battery holder itself and identifies the positioning of the cell(s) inside the
battery holder.
● + identifies the positive terminal(s) of equipment which is used with, or generates direct
current. + identifies the negative terminal(s) of equipment which is used with, or generates
direct current.
● Keep a minimum 200 mm (7.87 inch) distance around the equipment for sufficient ventilation.
● For certain models, ensure correct wiring of the terminals for connection to an AC mains supply.
● Use only power supplies listed in the user manual or user instruction.
● The USB port of the equipment is used for connecting to a mouse, keyboard, USB flash drive, or
Wi-Fi dongle only.
● Use only power supplies listed in the user manual or user instruction.
● Do not touch the sharp edges or corners.
● When the device is running above 45 °C (113 °F), or its HDD temperature in S.M.A.R.T. exceeds
the stated value, please ensure the device is running in a cool environment, or replace HDD(s)
to make the HDD temperature in S.M.A.R.T. below the stated value.
To Next Page
Need help?
General
