EN - Quick Guide
0
This manual is applicable for the following products:
HWI-XXXX, HWC-XXXX, HWP-XXXX.
X=0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z
IMPORTANT INFORMATION FOR SECURITY
You must carefully read this manual before use and installation of the camera and keep this manual
properly.
ATTENTION: Failure to comply with the following instructions may cause serious injury or death.
● In the use of the product, you must be in strict compliance with the electrical safety regulations
of the nation and region. Please refer to technical specifications for detailed information.
● This product is designed to be powered by supply unit under IEC60950-1. Please use a power
supply 110-240V , 47-63Hz, 2A / 12 , 5A (connector with positive central)
● Do NOT connect directly to the power grid for any reason.
● Do NOT connect several devices to one power adapter as adapter overload may cause over-
heating or a fire hazard.
● Make sure that the plug is firmly connected to the power socket. When the product is mounted
on wall or ceiling, the device shall be firmly fixed.
● If smoke, odor or noise rise from the device, turn off the power at once and unplug the power
cable, and then contact the service center. The installation should be carried out only by qualified
personnel and shall comply with all the rules.
ATTENTION: Failure to comply with the following instructions may cause injury or damage to device.
● Do NOT install the device near heat source such as radiators, vent of stove, or other source of
heat.
● Do NOT use the wires under excessive tension or compression loading.
● Do NOT drop the camera or subject it to physical shock.
● Do NOT use aggressive or abrasive detergents to clean body of the device.
● Only use accessories recommended by HIKVISION.
● Do not expose the camera directly to high concentrations of X-ray, laser or UV radiation. The
direct exposure may cause permanent damage to the image sensor.
● If the product does NOT work properly, please contact your dealer or the nearest service center.
Never attempt to disassemble the camera yourself.
To Next Page
Loading...
Need help?
General
