Network Camera User Manual
156
2. View the memory card status on Status Detection tab.
Remaining Lifespan: It shows the percentage of the remaining lifespan. The
lifespan of a memory card may be influenced by factors such as its capacity and
the bitrate. You need to change the memory card if the remaining lifespan is not
enough.
Health Status: It shows the condition of your memory card. There are thrree
status descriptions, good, bad, and damaged. You will receive a notification if the
health status is anything other than good when the Arming Schedule and
Linkage Method are set.
Note: It is recommended that you change the memory card when the health status
is not “good”.
3. Click R/W Lock tab to add a lock to the memory card.
With the R/W lock added, the memory card can only be read and write when it is
unlocked.
Figure 11-11 R/W Lock Setting
Add a Lock
(1) Select the Lock Switch as ON.
(2) Input the password.
(3) Click Save to save the settings.
Unlock
(1) If you use the memory card on the camera that locks it, unlocking will be
done automatically and no unlocking procedures are required on the part of
users.
(2) If you use the memory card (with a lock) on a different camera, you can go to
To Next Page
Loading...
Need help?
General
