Check the LPAR manager Dump
Note:
• The LPAR manager Dump is saved in non-volatile storage of the
Management Module. If a failure occurs, the dump may be automatically
collected. LPAR manager dump which has been automatically collected
will be overwritten by the LPAR manager dump manual operation. Check
first whether the LPAR manager dump has been automatically collected,
before the manual operation.
It is unnecessary to reboot LPAR manager after collecting the LPAR
manager dump.
Check the LPAR manager dump files by operations as follows.
1. Display the LP system logs screen.
2. Set the level selection to All level.
3. Check the LP System Logs which contains an Event of "LP dump
generation succeeded".
Figure 8-1 LP system logs Screen (LPAR manager Dump Exist)
If there is an LP System Logs entry saying "LPAR manager dump generation
succeeded", contact maintenance personnel. If that kind of LP System Logs
entry has not been obtained, follow the instructions below.
Collects the LPAR manager Dump
1. Display the LP Options screen.
2. Place the cursor on the Execute field under of Take LP Dump and press
Enter to display a sub-screen. Then select Yes on the sub-screen and
press Enter.
8-2
LPAR manager Dump Collection
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
Need help?
General