1. Remove the bolt and side cover
from the ratchet system.
2. Gently lift the shield, then the shield
will be released.
9 10
Shield Installation
Cheek Pad Removal
Cheek Pad Installation
1. Make sure of chin-bar position before shield installation.
2. Place the shield onto the ratchet gear by matching two tabs on the shield with ratchet system.
cident.
Crown Pad Removal
2. Repeat same at rear.
Crown Pad Installation
1. Install the front section first by aligning the plastic shel er
astic sleeve (center portion) into the center of the channel
pair your vision and may lead to an accident.
.
clear visor is also in closed position
Sunlight Film Operation
Removal
3. Place the side cover and insert the bolt. Make sure of bolt fastening.
2. Above illustration shows lowered sunlight film position.
1. Above illustration shows raised sunlight film position.
1. Bring down the sunlight film.
2. Hold the helmet tight and pull the sunlight film away from the helmet.
3. Once a “click” is audible, the sunlight film is released from the helmet.
There are 3 snaps holding the cheek pad in place.
1. Gently pry the check pad away from the interior, releasing
the snaps.
2. Grasp the cheek pad near its center and gently pull it free
from the chin strap.
1. Feed the chin strap through the opening in the cheek pad.
2. Align and fully slide the cheek pad plastic plate between shell and EPS.
3. Clip the cheek pad’s 3 small male snaps to the 3 female snaps fixed on the shell interior.
Shield Removal
Sunlight Film
To Next Page
Loading...
Need help?
General
