INSTALLATION AND USER GUIDE
69-2457EFS-03
RPLS730B / RPLS731B
Programmable Wall Switch
APPLICATIONS
The RPLS730B / RPLS731B programmable wall switch has been designed to
control lightings and motors:
INSTALLATION
NOTE: This switch cannot be used if there are not at least 2 white wires joined
by a connector inside the electrical box.
1. Cut power at the circuit breaker to avoid electric shock.
2. Remove the existing switch.
3. Install the new switch as shown in the diagram below.
4. Apply power at the circuit breaker.
Load type Maximum load Examples
Resistive load 2400 W (20 A @ 120 V) • incandescent lights
• halogen lights
• block heater
Inductive load 2400 W (20 A @ 120 V) • fluorescent lights
• compact fluorescent lights (CFL)
• sodium lamps
• electronic ballasts
Motor 1 hp • pool filter pumps
• fans
M38497
120 VAC (line)
blue (load)
white (neutral)
Load
black (line)
To Next Page
Need help?
General
