Honeywell Elmo FP8-C User Manual

with a small brush of the type illustrated below.
First, remove the pressure plate as follows:
1. Open the pressure plate holder by pushing
it to the right. It will stay open in this position.
2. Hold the pressure plate between the thumb
and forefinger and lift it up as far as it will go.
3. Pull the pressure plate straight out toward
you. Wipe it gently with a soft cloth, and replace
it by reversing the above procedure.
Before cleaning the aperture plate, remove the
pressure plate as described above. Then inspect
the aperture closely to make sure that the film
pulling claws are recessed and out of the way.
The claws are two tiny pins which become
visible in the aperture as you turn the film thread-
ing knob. If they are visible, turn the knob until
they disappear; then clean the aperture gate.
Replace the pressure plate, and close the pres-
sure plate holder.
To clean the projection lens, first remove it by
pulling it forward out of its mount. Wipe both
the front and rear elements gently with a camel
hair brush—do not use excessive pressure.
10

Honeywell Elmo FP8-C Specifications

General

Brand	Honeywell
Model	Elmo FP8-C
Category	Projector
Language	English