Setting and unsetting
Note: Ensure that all the areas protected by
movement detectors are free from
obstructions and all the doors and windows
are secured.
If an alarm, fault or tamper is displayed on the
keypad you must override it before setting the
system. Refer to Alarms, faults and tampers.
To full set the system:
1. Enter a valid Personal Identification Number
(PIN).
2. Press
A
.
3. Exit the building.
To part set the system:
1. Enter a valid PIN.
2. Press
B
.
3. Exit the building or area.
To set using a prox tag:
1. Present a valid prox tag to a proximity reader
for 3 seconds. This activates the prox tag’s full
set or part set function.
2. Exit the building or area.
If an alarm, fault or tamper is displayed on the
keypad, you must override it before setting the
system. Refer to Alarms, faults and tampers below.
To unset the system:
1. Enter a valid PIN.
2. Press
ent
.
Alternatively, present a valid prox tag at a proximity
reader.
To set the system with group choice:
1. Enter a valid PIN.
2. Press
A
.
3. If group choice is assigned to your PIN, press
the relative group number keys when prompted.
4. Press
ent
to select the groups to be set.
Alarms, faults and tampers
To cancel an alarm, fault or tamper:
1. Enter a valid PIN.
2. Press
ent
.
Alternatively, present a valid prox tag at a proximity
reader.
Resetting
After an alarm, fault or tamper has occurred the
system must be reset.
To Next Page
Need help?
General
