Google Play and the Google Play logo are trademarks of Google Inc.
IPCAM-WIC1 HD Wi-Fi Indoor Video Camera
Quick Installation Guide
IPCAM-WIC1 is an HD Wi-Fi video camera intended for indoor use with Honeywell Total Connect® 2.0.
Low-light operation
is indicated by two small red LEDs located on the front of the camera below the lens.
Camera setup requires a Total Connect® 2.0 account and the new Total Connect 2.0 mobile app. Video Services must
be enabled in AlarmNet 360™. Camera operation requires minimum available bandwidth of 1.5Mbps.
For best results, set up only one camera at a time.
Download the Total Connect® 2.0 app from the App Store or on Google Play.
(Look for the red Total Connect logo.)
a. Turn on your smart device’s Bluetooth and Wi-Fi.
b. Launch the app and sign in with your Total Connect® 2.0
account.
c. Remove the camera’s magnetic base; plug in the power
connector.
d. Replace the base but don’t connect the camera to AC power yet.
a. Press Cameras at the bottom of the app and then ADD CAMERA.
b. Select the type of camera you’re installing.
c. Name the camera and press NEXT.
The camera remains in setup mode for about 10 minutes.
a. Plug in the power supply. After about a minute, the camera
sounds a tone.
b. When the camera’s LED starts flashing blue, press NEXT on the app.
c. The app displays Pair Your Camera and a QR code appears. (This
can take up to 90 seconds.)
d. Show the QR code to the camera from 3 – 7 inches away. When
the code has been scanned, the camera sounds a tone.
e. When the app verifies the QR code, choose your system’s Wi-Fi
network and touch NEXT.
f. Enter the network password and press NEXT.
g. When camera registration is complete, the process is complete*.
Press DONE or ADD ANOTHER CAMERA.
After setup, go back to the Video tab and check your newly-
registered camera. Touch the thumbnail image to launch a live
stream from the camera.
*The app will tell you if you need to repeat the setup process.
This involves resetting the camera. See the other side of this
sheet for more information on using the Reset switch
To Next Page
Need help?
General
