® U.S. Registered Trademark
Copyright © 2009 Honeywell Inc. • All Rights Reserved EN0B-0237GE51 R0509
T7560A,B,C Digital Wall Module
HONEYWELL EXCEL 5000 OPEN SYSTEM
SPECIFICATION DATA
GENERAL
The T7560A,B Digital Wall Modules (DWM) display and
provide space temperature, setpoint, Occupied/Unoccupied
override, and fan mode/speed selection for the Honeywell
Excel 10 W7750, W7751H (see also Table 5,) W7752,
W7753, W7754, W7761, W7762, W7763, and Excel 800,
600, 500, 100, 50, 20 Controllers, as applicable. A software
module ModAL is available to adapt the wall module to the
respective Excel 20, 50, 100, 500, 600, 800 controller. See
T7560A,B,C Installation Instructions (product literature no.:
EN1B-0146GE51) for details.
Using the three buttons, the user can change room
temperature setpoint, fan mode/speed, initiate/cancel bypass,
and change configuration information such as the DWM’s
engineering units.
The T7560C Digital Wall Module (see inset above) has no
user interface (e.g. LCD, buttons, or setpoint dial) and issues
only temperature and humidity values.
These wall modules are not compatible with Honeywell
W7751A,C,E,G (VAV1) and W7752D1 (FCU1) Controllers.
FEATURES
• Fully compatible with all current Excel 10 and Excel
20 to 800 controllers.
• Low power consumption.
• Integral 20kΩ NTC sensor.
• Separate mounting base for easy installation.
• Tamper-resistant locking cover.
• IP30 housing.
• T7560A and B, only:
- LCD display continuously shows current space
temperature, occupied/unoccupied/standby mode,
fan status/mode, humidity, as configured.
- Push-button interface for full navigation and
change control of wall module functions.
- Single-touch occupied/unoccupied override.
- Setpoint dial for setpoint adjustment.
- Fan Speed/Mode commandable from buttons.
- Selectable °F/°C temperature display.
- Selectable setpoint type, absolute or relative.
To Next Page
Need help?
General
