Honeywell Voyager 1470g User Manual

38 Voyager XP User Guide
If the scanner and base have previously been linked, you do not receive any feed-
back. If this is the first time that the scanner and base are linked, both devices emit
a short chirp when their radios link. At this point, that one scanner is linked to one
base.
To determine if your cordless system is set up correctly, scan one of the sample
barcodes in the back of this manual. If the scanner provides a single good read
beep and the green LED lights, the scanner has successfully linked to the base. If
you receive an error tone and the red LED lights, the scanner has not linked to the
base. Refer to page 211 for troubleshooting information.
Link the Scanner to an Access Point
Turn on the computer (laptop/desktop). Plug the interface
cable into the Access Point first and then into the appropri-
ate port on the computer. The Page button lights up when
the connection to the host is made.
Scan the linking barcode on the top of the Access
Point to establish a connection between the
Access Point and the scanner. The scanner emits a
short beep and flashes the green LED to confirm a
connection with the Access Point. The Access
Point’s Page button remains blue.
CCB01-010BT-V1N Charge Base
Page
Button

Honeywell Voyager 1470g Specifications

General

Operating Temperature	0°C to 50°C (32°F to 122°F)
Environmental Sealing	IP40
Motion Tolerance	Up to 70 cm/s (27.6 in/s) for 13 mil UPC at optimal focus
Storage Temperature	-40°C to 60°C (-40°F to 140°F)
Weight	130 g (4.6 oz)
Humidity	0% to 95% relative humidity, non-condensing
Scan Pattern	Omnidirectional
Connectivity	USB, RS-232, Keyboard Wedge
Decode Capability	Reads standard 1D
Drop Specification	Withstands multiple 1.5 m (5 ft) drops to concrete
Light Levels	0 to 100, 000 lux
Dimensions	62 mm x 169 mm x 82 mm (2.5 in x 6.6 in x 3.2 in)
Light Source	LED