1
IMPORTANT SAFETY REMINDERS:
This cleaner should only be used for domestic cleaning, as described in this User
Guide. Please ensure that this guide is fully understood before operating the
appliance.
Warning: Electricity can be extremely dangerous. This appliance is double insulated
and must not be earthed. This plug is fitted with a 13 amp fuse (UK Only).
Important: The wires in the mains power lead are coloured in accordance with the
following code:
Blue - Neutral Brown - Live
Static electricity: Some carpets can cause a small build up of static electricity. Any
static electricity discharge is not hazardous to health.
Remember: After use, switch the cleaner off and remove the plug from the electricity
supply. Always switch off and remove the plug before cleaning the appliance or
attempting any maintenance.
Safety with children, elderly or the infirm: Do not let children play with the
appliance or its controls. Please supervise the use of the appliance by older children,
the elderly or the infirm.
IT IS IMPORTANT THAT YOU DO NOT
Position the cleaner above you when cleaning the stairs.
Use the cleaner out of doors on wet surfaces or for wet pickup.
Pick up matches, hot ash, cigarette ends, hard or sharp objects or anything that
may damage the cleaner.
Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours
as this may cause risk of fire/explosion.
Run over the supply cord whilst using the cleaner or remove the plug by pulling on
the cord.
Stand on or wrap the power cord around arms or legs when using the cleaner.
Continue to use your cleaner if it appears to be faulty. If the supply cord is
damaged, stop using the cleaner IMMEDIATELY. To avoid a hazard, an authorised
Hoover service engineer must replace the supply cord.
Remove the cyclonic cassette before removing the hose from the cleaner.
Use the appliance to clean people or animals.
ASSEMBLING YOUR CLEANER
Remove the cleaner and accessories form their packaging. Please dispose of the
packaging material in a safe and conscientious way.
Insert the hose end into the cleaner, ensuring it clips and locks into position. To
release: simply press the two buttons on the hose end and pull (P1).
GB
STD cyclonic t7_V2.qxp 12/03/2007 17:11 Page 1
To Next Page
Loading...
Need help?
General
