8
EN
EMPTYING THE CYCLONIC CASSETTE
Please empty the cassette after each use of the cleaner or if the cassette-check indicator is illumi-
nated (P17).
Remove the hose from the cleaner (P1).1.
Press the buttons on the handle (P18) and lift the cyclonic cassette out of cleaner(P19).2.
Hold the cassette upside down so that the outer lter panel faces upwards. Unlatch then 3.
unhinge the outer lter panel and remove from the cassette(P20). If the lters are dirty refer to
section ‘Cleaning the washable Filters’.
Unlatch the inner lter cover and open the cassette (P21). Carefully tip the contents of the 4.
cassette into a bin.
Use the brush nozzle (P12) when necessary to remove excessive dust from the internal 5.
surface of the cassette.
Close the inner lter cover ensuring the latch is located, replace the outer lter panel ensuring 6.
it is hinged and latched securely (P22 & P23).
Re-t the Freespace cyclonic cassette into the cleaner and push down on the cassette to
secure.
Important: The hose must be removed before removing or replacing the cyclonic cassette.
Remember: The cassette check indicator will also illuminate if an obstruction has occurred. In this
case refer to the section "Removing a blockage from the system".
CLEANING THE WASHABLE FILTERS
IMPORTANT: The cyclonic cassette is tted with 2 lters wich MUST BE CHECKED AND EX-
CESS DUST REMOVED each time the cassette is emptied. To remove dust, tap the lter against
the side of the bin to shake free excess dust.
To maintain optimum cleaning performance the lters MUST BE WASHED at least after EVERY
FIFTH TIME you empty the cassette.
To access the lters:
Remove the cyclonic cassette (P19).1.
Unlatch then unhinge the outer lter panel (P20).2.
Remove the foam lter (P24).3.
Wash the foam lter using warm water (P25). Do not use hot water or detergents. Remove 4.
excess water from the lter and leave to dry fully before re-using.
Gently tap and wash the micro lter attached to the lter frame using warm water (P26). Do 5.
not use hot water or detergents. Remove excess water from the lter and leave to dry fully
before re-using.
To remove the exhaust hepa lter: 6.
A. Unlatch and remove the exhaust lter cover (P27).
B. Remove the exhaust hepa lter.
Gently tap and wash the hepa lter (P28). Do not use hot water or detergents. 7.
Remove excess water from the lter and leave to dry fully before re-using.
To Next Page
Loading...
Need help?
General
