Boost
Use Level
3
Set-up
Water Care System
Functioning
Boost
Soft Button
Use the Boost
function to
increase the
sanitizer output.
Use pre- or post-
event when spa
use is more than
normal. Takes
24 hours to
complete.
Use Level
Soft Button
Select the Use
Level, choose
from 1 (min) to
5 (max), to
indicate how
much sanitizer
is needed.
Set-up
Soft Button
Access the
Set-up menu
to set the Spa
Size at start-up, or
to run a Salt Test.
Control Panel
Quick Reference Guide
Water Care Icon
• Static icon indicates system
is functioning.
• Flashing icon reminds you to
check your spa water every
30 days and/or indicates that
the system requires attention.
To Access the ACE
System Menu
Press the Options
hard button.
©2011 Watkins Manufacturing 10/11 PN 62761 rev. C
Water Care Icon
• Static icon indicates system
is functioning.
• Flashing icon reminds you to
check your spa water every
30 days and/or indicates that
the system requires attention.
MODE Buttons
Use these buttons to scroll
through the menu options.
Boost Feature
Use the Boost function to increase the
sanitizer output. Use pre- or post- event when
spa use is more than normal. Takes 24 hours to
complete. Press the MODE
▲
button until
bOOST is displayed. Press the OFF
▼
button
twice to set and confirm the Boost.
ON and OFF Buttons
Use the ON
▲
button to enter the
ACE menu when ACE is displayed on
the screen, or to adjust an ACE setting.
Use the OFF
▼
button to set and
confirm settings in the ACE menu.
To Access the ACE System Menu
Press the MODE
▲
button until ACE+ is displayed on the screen.
Then press the ON
▲
button to select the ACE menu.
Press the MODE
▲
button until EXIT+ is displayed on the screen.
Then press the ON
▲
button to select exit.
Salt Test Feature
Use this feature to test the salt level of the water. In
the ACE menu, press the MODE
▲
button until SALT
is displayed. Press the OFF
▼
button twice to set and
confirm a Salt Test. The OK range values for Salt are
between 3 and 6. Refer to the ACE Owner’s Manual if
your water is outside this range.