HPE 2530 24-Port and 48-Port Switches
Quick Setup Guide
The switch drawings in this document are for illustration only and may not match your particular switch
model.
For more detailed instructions and information to set up your switch, view or download the Installation
and Getting Started Guide for your switch at http://www.hpe.com/networking/support.
1. Unpack and check included parts.
• Documentation kit
• Switch
• Console port serial cable (DB-9 to RJ-45)
• Accessory kit (installation hardware)
• AC power cord
2. Prepare for installation. To avoid personal injury or product damage, review “Safety and Regulatory
Information for HPE 2530 24/48-Port Switches” (page 4).
3. Power on and verify that Self-Test completes normally. Power on the switch by connecting the power
cord through the AC power connector and switch on the power switch.
*5900-4818*
© Copyright 2014, 2015 Hewlett Packard Enterprise Development LP
The information in this document is subject to change without notice.
Part Number: 5900-4818
Published: November 2015
Edition: 2
To Next Page
Need help?
General
